Ich hab gerade eine Antwort von Bucktown Polymers erhalten:

----- Weitergeleitete Message ----- Von: Customer Service info@bucktownpolymers.com An: Jonathan Sieber jonathan_sieber@yahoo.de CC: Gesendet: 21:08 Donnerstag, 7.März 2013 Betreff: Re: UV Curable Resin

Jonathan

All the photopolymers listed here: http://bucktownpolymers.com/polymer00.html

Viscosity <100 cP's @25 C

Ec  <20mj/cm^2

Cure times for 0.1mm layers are under 2 seconds with a typical ~2700 lumen projector with a 100 x 70mm projection.

You can check the shipping costs to Germany by checking the Paypal links.

They are sensitive from UV up to ~440nm in the visible spectrum. So they may be used for your application since they are sensitive across the whole spectrum. We can also offer them sensitive to only below ~390nm UV.

Pricing and shipping rates are available by using the Paypal buttons for each photopolymer.

We have hundreds of formulas available and can also custom blend just about anything. Let us know if you are looking for something specific. We typically sell in 5 and 55 gallon (20kg, 200kg) drums or tankers. We offer a few resins in single gallons as a service for R&D labs or hobbyists.

Thank you for your interest!

Best regards,

Carl Wang

On 03/07/2013 01:37 PM, Jonathan Sieber wrote:

Hello,

I am planning a 3D Printer project and am interested in further specifications for your Photopolymers (especially your low-cost offers like PS100-V420).

Is there something like a datasheet for these materials? Information on viscosity, specific light amount / energy required for curing, recommended layer thickness etc. would be very useful.

And how much would shipment to Germany Cost?

I'm looking forward to your answer.

Best Regards, Jonathan Sieber